Fractals in the handFrattali in mano

Each of these solids is made by repeating one rule: the Menger sponge is a cube that keeps 20 of its 27 smaller cubes at every step, the Sierpinski tetrahedron is made of four half-size copies of itself that touch at the corners, and the Mandelbulb (the three-dimensional analogue of the Mandelbrot set found by White and Nylander in 2009) is traced here from its distance estimator. Of course, a printer can follow the repetition only down to roughly the width of its nozzle, and therefore only for a few levels.

Ognuno di questi solidi nasce ripetendo una sola regola: la spugna di Menger è un cubo che a ogni passo tiene 20 dei suoi 27 cubi più piccoli, il tetraedro di Sierpinski è fatto di quattro copie di se stesso a metà grandezza che si toccano nei vertici, e il Mandelbulb (l'analogo tridimensionale dell'insieme di Mandelbrot trovato da White e Nylander nel 2009) è tracciato qui dal suo stimatore di distanza. Naturalmente una stampante può seguire la ripetizione solo fino a circa la larghezza del suo ugello, e quindi solo per pochi livelli.

The solid that is printed, as it lies on the bed; drag to turn, wheel or pinch to zoom.Il solido che si stampa, come sta sul piano; trascina per ruotare, usa la rotella o il pizzico per lo zoom.

Print itStampalo

A 3D print of this fractalUna stampa 3D di questo frattale

The solid above can be ordered as a 3D print, which lies on a face for the sponge, on an edge cut flat for the tetrahedron (which therefore needs no supports) and on a flat cut for the Mandelbulb, which is printed with supports or in resin. The request sends the link to the fractal as it is on the screen.

Puoi ordinare il solido qui sopra come stampa 3D, appoggiato su una faccia se è la spugna, su uno spigolo tagliato in piano se è il tetraedro (che quindi non ha bisogno di supporti) e su un taglio piano se è il Mandelbulb, che si stampa con i supporti o in resina. La richiesta manda il link al frattale così com'è sullo schermo.

The sponge lies on a face: its tunnels have flat ceilings, a third of the side wide at most, which most printers bridge (at level 1 with a large size, supports help). The tetrahedron stands on an edge cut flat, where no face looks down more than 35° from the vertical, so it needs no supports; if it lies on a face, instead, its holes have flat ceilings. The Mandelbulb has overhangs almost everywhere, and therefore it needs supports or, better, a resin printer; the base is a flat cut, and the thickness added to its surface keeps the thinnest filaments printable.

La spugna sta su una faccia: le gallerie hanno soffitti piani, larghi al più un terzo del lato, che la maggior parte delle stampanti fa a ponte (al livello 1 e in grande servono supporti). Il tetraedro sta su uno spigolo tagliato in piano, dove nessuna faccia guarda in basso più di 35° dalla verticale, quindi non servono supporti; se invece lo si appoggia su una faccia, i suoi buchi hanno soffitti piani. Il Mandelbulb ha sbalzi quasi ovunque, e quindi servono i supporti o, meglio, una stampante a resina; la base è un taglio piano, e lo spessore aggiunto alla superficie rende stampabili i filamenti più sottili.